Alpha Mobile Solutions (800) 789-1212 (call Alpha Mobile Solutions)

Blog ·

ADA Shower Dimensions: What the Standards Say and What It Means for a Shower Trailer

The ADA Single Restroom and Restroom Shower Trailer features a gray accessible shower with grab bars on two walls, a mounted showerhead, handheld shower, and a non-slip floor with central drain.

Under the 2010 ADA Standards for Accessible Design, there are three accessible shower sizes. A transfer type shower is 36 inches by 36 inches inside. A standard roll-in shower is at least 30 inches wide by 60 inches deep, with a 60-inch-wide entry. An alternate roll-in shower is 36 inches wide by at least 60 inches deep. Each one also needs clear floor space in front of it, and every inside measurement is taken at the center points of opposing sides.

That is the short answer. If you are buying a shower trailer for a crew, a camp, a shelter or a response team, those numbers decide how the room is laid out, how big the trailer has to be and who can use it on their own. This guide walks through each shower type, the clearances, the controls and the hand-held spray, then what to ask before you order.

This article is general information, not legal or design advice. Your project's requirements depend on how and where the trailer is used, so confirm them with your own accessibility consultant or the authority that reviews your site.

Where the ADA shower rules come from

The rules for accessible showers sit in Section 608, Shower Compartments, in Chapter 6 of the ADA Standards. The U.S. Access Board publishes the guidelines with diagrams on its Chapter 6: Plumbing Elements and Facilities page, and the Department of Justice publishes the same text in the 2010 ADA Standards for Accessible Design. Section 608 covers the size and clearance of the shower, grab bars, seats, controls, the shower spray unit and thresholds. The size and clearance rules below are taken from those pages.

Transfer type shower: 36 by 36 inches

A transfer shower is built for a person who moves from a wheelchair onto a shower seat. The standard says it must be 36 inches by 36 inches clear inside, measured at the center points of opposing sides, with an entry at least 36 inches wide on the face of the shower.

In front of it you need clear floor space at least 36 inches wide and 48 inches long, measured from the control wall. That clear floor space has to stay open.

A transfer shower is the most compact accessible option, and its size is set at 36 by 36 inches rather than given as a minimum.

Standard roll-in shower: 30 by 60 inches minimum

A roll-in shower lets a person stay in a shower wheelchair and roll straight in. The standard roll-in type must be at least 30 inches wide by 60 inches deep clear inside, with an entry at least 60 inches wide on the face of the shower. In other words, the long side is the open side.

Beside the open face you need a clearance at least 30 inches wide by 60 inches long. The standard allows one exception: a lavatory that meets Section 606 may sit on one 30-inch side of that clearance, as long as it is not on the side next to the controls or, where there is one, the shower seat.

Alternate roll-in shower: 36 by 60 inches

The alternate roll-in type is 36 inches wide and at least 60 inches deep clear inside. It has the same 60-inch minimum depth as the standard roll-in type and is 6 inches wider inside. Its entry and clearance rules are set out in Section 608 as well, so ask your builder to show them on the floor plan.

Controls and the hand-held shower spray

Size is only half of it. Section 608 also sets rules for what the user touches:

  • Controls. Controls, faucets and shower spray units must comply with Section 309.4 of the standards, the rule for operable parts.
  • Shower spray unit. The shower needs a spray unit with a hose at least 59 inches long that works both as a fixed shower head and as a hand-held shower.
  • On and off. The spray unit needs an on/off control with a non-positive shut-off.

Grab bars, the seat and the threshold each have their own rules in Section 608 as well. Ask your builder to show you how each one is placed on the drawing, not only that it is included.

What this means inside a shower trailer

A trailer is a narrow box, so accessible shower rooms take planning. The shower stall, its clear floor space, the turning space in the room and the path from the door all have to fit inside the trailer's width, so plan them together from the start.

Getting into the room matters as much as the shower. On our ADA single restroom and shower trailer, access is by an ADA ramp system with 1-1/4 inch stainless steel railings and a 36-inch-wide entry door. The handrails and grab bars are 1-1/2 inch stainless steel, and the interior turning radius and exterior landing turning radius meet or exceed ADA requirements. The unit carries a 105-gallon onboard fresh water tank, a 6-gallon electric water heater, a city water hook-up and a roof-mounted air conditioner with heat strip. When you request a quote, ask us for the shower layout drawing so you can check it against the dimensions above.

The systems behind the shower work the same way they do in any of our trailers. If you want the details on water supply, hot water and drainage, our guide on how a mobile shower trailer works covers each one.

Questions to ask before you order

  1. Which shower type is it? Transfer, standard roll-in or alternate roll-in. Each has different dimensions and a different clearance.
  2. Where are the measurements taken? The standard measures clear inside dimensions at the center points of opposing sides, so ask for the drawing to show it that way.
  3. Is the clear floor space kept open? Check that no sink, bench or storage sits in the clearance, except where the standard allows it.
  4. What spray unit is installed? Look for a hose of at least 59 inches that works fixed and hand-held.
  5. How does a wheelchair user reach the room? Look at the ramp, railings, door width and landing.
  6. How many accessible showers do you need? That depends on your site and how the trailer is used, so confirm it with whoever reviews your project.

To see how our units compare on rooms, size and features, use the trailer comparison page.

Frequently asked questions

What size is an ADA transfer shower?

A transfer type shower is 36 inches by 36 inches clear inside, measured at the center points of opposing sides, with an entry at least 36 inches wide. It needs clear floor space at least 36 inches wide and 48 inches long in front of it, measured from the control wall.

What size is an ADA roll-in shower?

A standard roll-in shower is at least 30 inches wide by 60 inches deep inside, with an entry at least 60 inches wide and a clearance at least 30 by 60 inches beside the open face. An alternate roll-in shower is 36 inches wide by at least 60 inches deep.

How long does the hand-held shower hose have to be?

At least 59 inches. The spray unit has to work both as a fixed shower head and as a hand-held shower, with an on/off control that has a non-positive shut-off.

Can a shower trailer be ADA-compliant?

Yes. A trailer can be built to provide an accessible shower room and ramp entry. Our ADA single restroom and shower trailer is ADA-compliant, with a ramp, a 36-inch entry door and stainless steel grab bars.

What is the difference between a transfer shower and a roll-in shower?

In a transfer shower, the user moves from a wheelchair onto a shower seat, so the stall is a compact 36 by 36 inches. In a roll-in shower, the user stays in a shower wheelchair and rolls in, so the stall is at least 60 inches deep.

Build an accessible shower trailer

Tell us how many people need an accessible shower and where the trailer will sit, and we will quote it. Build your trailer and get a quote, or call (800) 789-1212, Mon to Fri 9 to 5 CT. We build and sell trailers. We do not rent them.

Keep reading: How Much Does a Shower Trailer Cost? What Sets the Price of a Built-to-Order Unit, How Does a Mobile Shower Trailer Work? Water, Hot Water, Drainage and Power and Shower and Restroom Trailers for Workforce Housing and Remote Crews.

Tell us what you need. We will quote it.

Build your trailer in a few steps, or call (800) 789-1212, Mon–Fri 9–5 CT. We build and sell trailers. We do not rent them.

Keep reading

Call 800-789-1212 Build your trailer